2017 Mercedes-Benz S550 Stock Height with 20×9 / 20×11 Niche Prodigy 5 & 245/40R20 / 285/35R20 Tires

2017 Mercedes-Benz S550 Wheel and Tire Setup

This 2017 Mercedes-Benz S550 runs a staggered set of Niche Prodigy 5 wheels finished in silver with a machined face, with a 20×9 front wheel and a 20×11 rear wheel wrapped in 245/40R20 front and 285/35R20 rear tires. The suspension remains at factory ride height per the gallery notes, making the wheel and tire package the main change in stance on this W222 S-Class.

The split five-spoke Prodigy 5 design suits the S550’s long rear quarter especially well because the deeper rear concave face fills the opening without looking thin against the wide hip. The silver machined face stays bright against the white bodywork while still showing the spoke detail on Miami streets and garage floors.

Factory vs New Specs

A common Sport-style factory setup on the 2017 Mercedes-Benz S550 uses a staggered 19×8.5 front wheel with a 245/45R19 tire and a 19×9.5 rear wheel with a 275/40R19 tire. Base packages also used 18×8 wheels with 245/50R18 tires depending on options.

Factory Wheel: Approximately 19×8.5 +36 front and 19×9.5 +43 rear on the common Sport-style layout.

Factory Tire: 245/45R19 front measuring approximately 27.68 inches tall, and 275/40R19 rear measuring approximately 27.66 inches tall.

New Wheel: 20×9 Niche Prodigy 5 front and 20×11 Niche Prodigy 5 rear.

New Wheel Offset: +45mm front and +44mm rear.

New Tire: 245/40R20 front measuring approximately 27.72 inches tall, and 285/35R20 rear measuring approximately 27.85 inches tall.

Wheel Diameter: The wheel increases by 1 inch on both axles, from 19 inches to 20 inches.

Wheel Width: Front width increases from approximately 8.5 inches to 9 inches. Rear width increases from approximately 9.5 inches to 11 inches.

Tire Width: Front nominal tire width stays at 245mm. Rear nominal tire width increases from 275mm to 285mm.

Tire Diameter and Ground Clearance

The factory front 245/45R19 measures approximately 27.68 inches tall, while the 245/40R20 measures approximately 27.72 inches.

That is a difference of only about 0.04 inch in overall front diameter, or roughly 0.1 percent. Static ground clearance at the front axle is effectively unchanged from the tire itself.

At the rear, the factory 275/40R19 measures approximately 27.66 inches, while the 285/35R20 measures approximately 27.85 inches. That is about 0.19 inch taller overall, or about 0.10 inch more static clearance at the rear axle.

Speedometer difference remains negligible. Using the front diameters as the reference, actual road speed is approximately 0.1 percent higher than the indicated speed.

Offset and Wheel Position

The Niche Prodigy 5 package for this application uses a 20×9 front wheel at +45mm and a 20×11 rear wheel at +44mm. Compared with a factory-style 19×8.5 +36 front and 19×9.5 +43 rear setup, the front gains 0.5 inches of width with 9mm more positive offset, and the rear gains 1.5 inches of width with 1mm more positive offset.

Up front, the outer edge sits approximately 3mm, or about 0.10 inch, farther inward than the factory front wheel, while the inner edge moves about 15mm closer to the suspension.

At the rear, the outer edge sits approximately 18mm, or about 0.71 inch, farther out, and the inner edge moves about 20mm, or roughly 0.79 inch, closer to the suspension. The net result is a flush staggered stance that puts more silver Prodigy 5 face in the rear opening while keeping the front near the factory track.

Fitment and Stance

Keeping a staggered layout follows the way sportier S-Class packages were designed. The extra inch of diameter, the half-inch wider front wheel and the much wider rear wheel put more silver machined Prodigy 5 face in the arches without converting the car to a square setup.

The 245 front and 285 rear tires keep section width matched to the 9 and 11 inch barrels, so the package reads aggressive without looking over-stretched on either axle.

At the ride height shown in the gallery, the 20 inch wheels close up the arch gap that smaller factory packages leave on these S550s while the staggered rear still prioritizes the wide-hip look the chassis was built around.

Fitment Notes

Suspension: Gallery notes list this build at factory ride height with no lift required for the wheel and tire package shown here. Final ride-height hardware should still be confirmed on the vehicle during installation, especially on Airmatic-equipped cars.

Tire Size: 245/40R20 front and 285/35R20 rear are commonly paired with 20×9 and 20×11 wheels on the W222 S-Class and keep overall diameters extremely close to the factory 19 inch Sport-style tires.

Rubbing: The gallery fitment notes list no rubbing and no trimming for this build. Final clearance should still be checked through full steering lock and suspension compression during installation, especially with the wider rear package.

Poke: Front +45mm and rear +44mm keep the staggered Prodigy 5 package near flush, with the front slightly more tucked than the factory reference and about 18mm more rear poke than the factory rear wheel.

Inner Clearance: Front inner clearance tightens about 15mm versus the Sport-style reference, while the rear inner edge moves about 20mm closer to the suspension and should be checked at full compression.

Center Bore: The Niche Prodigy 5 in 5×112 uses a 72.56mm center bore, larger than the S550’s 66.6mm hub, so the proper hub-centric rings should be used during installation.

Wheel Load Rating: The cataloged 20 inch Prodigy 5 variants for this package list an 1,800 pound load rating per wheel. Tire load capacity should also be verified for the vehicle.

Ride and Drivability

The biggest drivability change comes from the reduced tire sidewall. Moving from 45-series front and 40-series rear factory tires to 40-series front and 35-series rear 20 inch tires shortens the rubber between the wheel and the road, so sharper impacts will be more noticeable on Miami streets and highway expansion joints.

At the same time, keeping overall tire diameters extremely close to the common 19 inch Sport-style package helps preserve gearing, ride height and speedometer accuracy.

The wider 285 rear footprint also puts more rubber on the ground than the original 275 rear tire without jumping to an extreme track-only rear width.

Stock Suspension

The 2017 Mercedes-Benz S550 uses a multi-link front and rear suspension, and many examples were equipped with AIRMATIC air suspension. Exact spring and damper hardware can vary even when ride height remains stock.

For gallery fitment purposes, the important detail is that this build is documented at factory ride height and does not rely on a lift modification to accommodate the 20 inch staggered wheel and tire package.

Fitment Dynamics Miami

Fitment Dynamics carries wheels, tires and suspension upgrades for Mercedes-Benz S-Class applications, including Niche wheel and tire packages in 18, 19, 20 and 22 inch fitments. Our team can help determine the proper wheel width, offset and tire size while accounting for fender clearance, suspension clearance, load capacity and everyday drivability.

Customers can visit Fitment Dynamics in the Miami area for professional wheel and tire installation, fitment assistance and local pickup, or have their wheel and tire package shipped nationwide directly to their door.

Fitment Dynamics
8224 NW South River Dr
Medley, FL 33166
786-244-5565