2016 GMC Yukon Stock Height with 24×10 Niche Serene & 305/35R24 Tires
Wheel Specs:
Niche Serene 24×10 Offset: 30
Rear Wheel Specs:
24×
10
Offset: 30
Tire Specs:
Front Size: 305/35R24
Rear Size: 305/35R24
Wheel & Tire Fitment Notes
Flush
No Rubbing
No Trimming
Suspension:
Stock Height
2016 GMC Yukon Wheel and Tire Setup
This 2016 GMC Yukon runs a square set of 24×10 Niche Serene wheels finished in gloss titanium brushed and wrapped in 305/35R24 tires at all four corners. The suspension remains at factory ride height, making the oversized wheel and tire package responsible for the dramatic change in stance on this K2XX Yukon.
The thin multi-spoke Serene design suits the Yukon’s tall body especially well because the dense spoke pattern visually fills the 24 inch diameter without looking sparse against the large fender openings. The gloss titanium brushed finish adds a brighter metallic contrast against the dark metallic bodywork and keeps the package looking premium on Miami streets and rooftop lots.
Factory vs New Specs
A common factory setup on the 2016 GMC Yukon uses a 20×9 wheel with a +27mm offset and a 275/55R20 tire measuring approximately 31.9 inches tall. Other factory packages included 18×8.5 with 265/65R18 and 22×9 with 285/45R22 depending on options.
Factory Wheel: Approximately 20×9 +27.
Factory Tire: 275/55R20, measuring approximately 31.91 inches tall.
New Wheel: 24×10 Niche Serene at all four corners.
New Wheel Offset: +30mm.
New Tire: 305/35R24, measuring approximately 32.41 inches tall.
Wheel Diameter: The wheel increases by 4 inches, from 20 inches to 24 inches.
Wheel Width: Width increases from approximately 9 inches to 10 inches.
Tire Width: Nominal tire width increases from 275mm to 305mm.
Tire Diameter and Ground Clearance
The factory 275/55R20 measures approximately 31.91 inches tall, while the 305/35R24 measures approximately 32.41 inches.
That is a difference of about 0.50 inch in overall diameter, or roughly 1.6 percent. Static ground clearance increases by about 0.25 inch from the tire itself.
Keeping overall diameter this close to the common 20 inch factory tire is one of the reasons 305/35R24 works so well on a 24×10 Serene. The Yukon gets the appearance of a much larger wheel without a large change in rolling height.
Speedometer difference remains small. Because the 305/35R24 is only slightly taller than the common 20 inch factory tire, actual road speed is approximately 1.6 percent higher than the indicated speed.
Offset and Wheel Position
The Niche Serene used for this application measures 24×10 with a +30mm offset. Compared with a factory-style 20×9 +27 wheel, the new wheel is one inch wider and uses 3mm more positive offset.
When both width and offset are considered, the outer edge of the Serene sits approximately 10mm, or about 0.38 inch, farther outward per side than the factory reference wheel.
The inside edge moves about 16mm, or roughly 0.62 inch, closer to the suspension because the added width is larger than the small offset change. That still produces the fuller, near-flush stance visible on the finished Yukon while remaining within a workable street fitment range for the K2XX chassis.
Fitment and Stance
The 24×10 +30 wheel paired with a 305/35R24 tire gives the Yukon a much stronger street-oriented stance while remaining close to the original overall tire diameter.
The additional wheel width moves the package closer to the fender line, while the 305 tire fills the 10 inch barrel without stretching into an extreme section width.
At stock ride height, the large 24 inch wheel fills the K2XX opening. The thin 35-series sidewall and slightly taller overall diameter close up the arch gap that stock 20 inch packages leave on these SUVs.
Fitment Notes
Suspension: This build remains at factory ride height with no lift or lowering kit required for the appearance shown here.
Tire Size: 305/35R24 is a commonly used size with 24×10 wheels on full-size GM SUVs and keeps overall diameter within roughly two percent of the factory 275/55R20.
Rubbing: The gallery fitment notes list no rubbing and no trimming for this build. Final clearance should still be checked through full steering lock and suspension compression during installation.
Poke: The +30mm offset with the wider 10 inch barrel places the wheel farther toward the fender than the factory +27 setup. The result is an aggressive, near-flush appearance rather than the more tucked factory wheel position.
Inner Clearance: The wider wheel moves the inner edge about 16mm closer to the suspension than the factory 20×9 +27 reference, so brake, control-arm and full-lock clearance should be verified at install.
Center Bore: The Niche Serene in 6×135/6×139.7 uses a 100.3mm center bore, larger than the Yukon’s 78.1mm hub, so the proper hub-centric rings should be used during installation.
Wheel Load Rating: The 24×10 Niche Serene has a 2,500 pound load rating per wheel. Tire load capacity should also be verified for the Yukon application.
Ride and Drivability
The biggest drivability change comes from the reduced tire sidewall. Moving from a 275/55R20 to a 305/35R24 dramatically reduces the amount of rubber between the wheel and the road, so sharper impacts will be more noticeable on Miami streets and highway expansion joints.
At the same time, keeping overall tire diameter close to the common 20 inch factory package helps preserve gearing, ride height and speedometer accuracy.
The 305mm tire also provides a wider footprint than the original 275mm tire without jumping to an extreme track width for the 10 inch wheel.
Stock Suspension
The 2015–2020 GMC Yukon (K2XX) uses an independent front and rear suspension. Coil springs were standard across much of the lineup, with Magnetic Ride Control available on Denali packages, so exact damper and spring hardware can vary by vehicle even when ride height remains stock.
For gallery fitment purposes, the important detail is that this build maintains its factory ride height and does not rely on a lift or lowering modification to accommodate the 24 inch wheel and tire package.
Fitment Dynamics Miami
Fitment Dynamics carries wheels, tires and suspension upgrades for GMC Yukon applications, including Niche wheel and tire packages in 22, 24 and 26 inch fitments. Our team can help determine the proper wheel width, offset and tire size while accounting for fender clearance, suspension clearance, load capacity and everyday drivability.
Customers can visit Fitment Dynamics in the Miami area for professional wheel and tire installation, fitment assistance and local pickup, or have their wheel and tire package shipped nationwide directly to their door.
Fitment Dynamics
8224 NW South River Dr
Medley, FL 33166
786-244-5565






