2013 Chevrolet Tahoe Stock Height with 26×10 Niche Prodigy 6 & 295/30R26 Tires
Wheel Specs:
Niche Prodigy 6 26×10 Offset: 20
Rear Wheel Specs:
26×
10
Offset: 20
Tire Specs:
Front Size: 295/30R26
Rear Size: 295/30R26
Wheel & Tire Fitment Notes
Flush
No Rubbing
No Trimming
Suspension:
Stock Height
2013 Chevrolet Tahoe Wheel and Tire Setup
This 2013 Chevrolet Tahoe runs a square set of 26×10 Niche Prodigy 6 wheels finished in gloss black with a dark tinted clear and wrapped in 295/30R26 tires at all four corners. The suspension remains at factory ride height, making the oversized wheel and tire package responsible for the dramatic change in stance on this GMT900 Tahoe.
The six-spoke Prodigy 6 design suits the Tahoe’s large fender openings especially well because the concave face visually fills the 26 inch diameter without looking thin against the tall body. The dark tinted clear adds a smoked effect over the gloss black finish and complements the blacked-out grille, trim and body color shown on this build.
Factory vs New Specs
A common factory setup on the 2013 Chevrolet Tahoe uses a 17×7.5 wheel with a +31mm offset and a 265/70R17 tire measuring approximately 31.6 inches tall. Other factory packages included 18×8 with 265/65R18 and 20×8.5 with 275/55R20 depending on options.
Factory Wheel: Approximately 17×7.5 +31.
Factory Tire: 265/70R17, measuring approximately 31.61 inches tall.
New Wheel: 26×10 Niche Prodigy 6 at all four corners.
New Wheel Offset: +20mm.
New Tire: 295/30R26, measuring approximately 32.97 inches tall.
Wheel Diameter: The wheel increases by 9 inches, from 17 inches to 26 inches.
Wheel Width: Width increases from approximately 7.5 inches to 10 inches.
Tire Width: Nominal tire width increases from 265mm to 295mm.
Tire Diameter and Ground Clearance
The factory 265/70R17 measures approximately 31.61 inches tall, while the 295/30R26 measures approximately 32.97 inches.
That is a difference of about 1.36 inches in overall diameter, or roughly 4.3 percent. Static ground clearance increases by about 0.68 inch from the tire itself.
Even with that increase, 295/30R26 remains the standard pairing for a 26×10 Prodigy 6 because it keeps the thin 30-series sidewall look while restoring overall height after the nine-inch jump in wheel diameter.
Speedometer difference is moderate. Because the 295/30R26 is taller than the common 17 inch factory tire, actual road speed is approximately 4.3 percent higher than the indicated speed.
Offset and Wheel Position
The Niche Prodigy 6 used for this application measures 26×10 with a +20mm offset. Compared with a factory-style 17×7.5 +31 wheel, the new wheel is 2.5 inches wider and uses 11mm less positive offset.
When both width and offset are considered, the outer edge of the Prodigy 6 sits approximately 43mm, or about 1.7 inches, farther outward per side than the factory reference wheel.
The inside edge also moves about 21mm, or roughly 0.8 inch, closer to the suspension. Most of the additional wheel width is still directed toward the outside of the vehicle, which creates the fuller, near-flush stance visible on the finished Tahoe.
Fitment and Stance
The 26×10 +20 wheel paired with a 295/30R26 tire gives the Tahoe a much stronger street-oriented stance while remaining on factory ride height.
The additional wheel width and lower offset move the package closer to the fender flare, while the 295 tire keeps section width controlled compared with a wider 305 on the same 10 inch wheel.
At stock ride height, the large 26 inch wheel fills the GMT900 opening. The thin 30-series sidewall and slightly taller overall diameter close up the arch gap that stock 17 inch packages leave on these trucks.
Fitment Notes
Suspension: This build remains at factory ride height with no lift or lowering kit required for the appearance shown here.
Tire Size: 295/30R26 is a commonly used size with 26×10 wheels on full-size GM SUVs and restores overall height after the diameter jump from a factory 17 inch package.
Rubbing: The gallery fitment notes list no rubbing and no trimming for this build. Final clearance should still be checked through full steering lock and suspension compression during installation.
Poke: The +20mm offset places the wheel noticeably farther toward the fender than the factory +31 setup. The result is an aggressive, near-flush appearance rather than the deep-tucked factory wheel position.
Inner Clearance: The 10 inch width and +20mm offset move the inner lip inward relative to the factory 17×7.5 +31 wheel, so liner and suspension clearance should be verified during install.
Center Bore: The Niche Prodigy 6 in 6×139.7 uses a 106.1mm center bore, larger than the Tahoe’s 78.1mm hub, so the proper hub-centric rings should be used during installation.
Wheel Load Rating: The 26×10 Niche Prodigy 6 has a 2,500 pound load rating per wheel. Tire load capacity should also be verified for the Tahoe application.
Ride and Drivability
The biggest drivability change comes from the reduced tire sidewall. Moving from a 265/70R17 to a 295/30R26 dramatically reduces the amount of rubber between the wheel and the road, so sharper impacts will be more noticeable on Miami streets and highway expansion joints.
At the same time, the slightly taller overall diameter versus a common 17 inch factory tire raises rolling height a little and shifts speedometer reading as noted above.
The 295mm tire also provides a wider footprint than the original 265mm tire without going unnecessarily wide for the 10 inch wheel.
Stock Suspension
The 2007–2014 Chevrolet Tahoe uses an independent front suspension and a solid rear axle on coil springs. Optional damper packages were available on some trims, so exact hardware can vary even when ride height remains stock.
For gallery fitment purposes, the important detail is that this build maintains its factory ride height and does not rely on a lift or lowering modification to accommodate the 26 inch wheel and tire package.
Fitment Dynamics Miami
Fitment Dynamics carries wheels, tires and suspension upgrades for Chevrolet Tahoe applications, including Niche wheel and tire packages in 22, 24 and 26 inch fitments. Our team can help determine the proper wheel width, offset and tire size while accounting for fender clearance, suspension clearance, load capacity and everyday drivability.
Customers can visit Fitment Dynamics in the Miami area for professional wheel and tire installation, fitment assistance and local pickup, or have their wheel and tire package shipped nationwide directly to their door.
Fitment Dynamics
8224 NW South River Dr
Medley, FL 33166
786-244-5565






